DTF Transfer Instructions(UV & Textile)
Textile Transfers (Fabric) DTF Application Instructions:
- Design Preparation:
- Create or select your design using graphic design software that supports DTF printing.
- Ensure the dimensions of your design match the size of your fabric or garment.
- Preparation of Fabric:
- Pre-heat your textile fabric or garment on the heat press to eliminate any moisture and wrinkles.
- Positioning the DTF Film:
- Place the cured DTF film with the adhesive side facing down onto the fabric.
- Carefully align the design correctly on the fabric.
- Heat Press Setup:
- Pre-heat your heat press to 315-320°F (approximately 157-160°C).
- Pressing Process:
- Cover the DTF film and fabric with a Teflon sheet or parchment paper to protect both the fabric and the heat press platen.
- Press the fabric and DTF film together using the heat press at the recommended temperature and time. Typically, this is around 315-320°F (157-160°C) for 15 seconds.
- Apply medium to high pressure to ensure the design adheres properly to the fabric.
- Cooling and Peeling:
- After heat pressing, allow the fabric to cool for a few seconds while still covered.
- Peel off the DTF film carefully and smoothly in a consistent motion to reveal the transferred design on the fabric.
- Re-pressing:
- Preferably, re-press the fabric with the design exposed for an additional 15 seconds to ensure secure adhesion.
- Final Check:
- Allow the fabric to cool completely before handling.
- Your DTF transfer is now complete, and the design should be securely adhered to the fabric.
UV DTF Stickers Application Instructions:
- Prepare the Surface:
- Clean the surface thoroughly to remove any dirt, grease, or debris.
- Ensure the surface is completely dry before applying the sticker.
- Avoid using alcohol or solvents that could damage the adhesive.
- Cut the Sticker:
- Cut out the sticker or decal, trimming away any excess clear carrier sheet around the design.
- Position the Sticker:
- Fold back a small part of the backing and align the center of the sticker with where you want it placed.
- Press down firmly in the center of the sticker and then gradually smooth outwards towards the edges to prevent air bubbles.
- Squeegee the Sticker:
- Use the padded end of a squeegee or a credit card to apply firm and even pressure over the entire surface of the sticker.
- Stroke back and forth 2–4 times, paying particular attention to small or intricate design elements.
- Peel the Backing:
- Starting from a corner or an edge, slowly peel away the clear carrier sheet from the sticker.
- If any part of the sticker begins to lift with the carrier sheet, gently press it back down with your fingers before continuing.
- Activate the Adhesive:
- Once the sticker is applied, use your body temperature to activate the adhesive.
- Gently rub over the entire surface of the sticker with your hand or a soft cloth for 3–5 minutes.
- This process helps the sticker adhere securely and reduces the chances of lifting.